Difference between revisions of "AUTOEXEC"
(starting MSDOS is not a common autoexec :)) |
|||
| (6 intermediate revisions by 4 users not shown) | |||
| Line 1: | Line 1: | ||
| − | + | Upon BOOT, the original MS-DOS system would first load settings from a file called CONFIG.SYS, and then execute any commands found in the '''AUTOEXEC.BAT''' file. Commonly the AUTOEXEC.BAT file would define the system [[PATH]], load device drivers, and launch [[Software:Windows|Windows]]. Because DOSBox already emulates most of what a CONFIG.SYS, and AUTOEXEC.BAT would do, there isn't much need to define anything other than your mountable drives. | |
| − | + | In DOSBox, '''AUTOEXEC.BAT''' is a [[Dosbox.conf#sections |section]] of the [[dosbox.conf]] file. The section is labeled as '''[autoexec]'''. | |
== A Common AUTOEXEC.BAT == | == A Common AUTOEXEC.BAT == | ||
| Line 8: | Line 8: | ||
C: | C: | ||
CLS | CLS | ||
| − | + | ECHO Hello world... | |
| − | |||
This '''AUTOEXEC.BAT''' file [[MOUNT|mounts]] a [[CDrive|C drive]] (pointed to the Local-Directory C:\DOSGAMES), changes to that drive (from [[ZDrive|Z:]]), [[Commands#CLS|Clears the Screen]] and prints the message | This '''AUTOEXEC.BAT''' file [[MOUNT|mounts]] a [[CDrive|C drive]] (pointed to the Local-Directory C:\DOSGAMES), changes to that drive (from [[ZDrive|Z:]]), [[Commands#CLS|Clears the Screen]] and prints the message | ||
| − | + | Hello world... | |
(The message that MS-DOS printed immediately before loading the '''CONFIG.SYS''' and '''AUTOEXEC.BAT'''). | (The message that MS-DOS printed immediately before loading the '''CONFIG.SYS''' and '''AUTOEXEC.BAT'''). | ||
| Line 18: | Line 17: | ||
MOUNT C C:\oldgames | MOUNT C C:\oldgames | ||
C: | C: | ||
| − | |||
| − | |||
Latest revision as of 09:02, 31 October 2009
Upon BOOT, the original MS-DOS system would first load settings from a file called CONFIG.SYS, and then execute any commands found in the AUTOEXEC.BAT file. Commonly the AUTOEXEC.BAT file would define the system PATH, load device drivers, and launch Windows. Because DOSBox already emulates most of what a CONFIG.SYS, and AUTOEXEC.BAT would do, there isn't much need to define anything other than your mountable drives.
In DOSBox, AUTOEXEC.BAT is a section of the dosbox.conf file. The section is labeled as [autoexec].
A Common AUTOEXEC.BAT
@ECHO OFF MOUNT C C:\DOSGAMES C: CLS ECHO Hello world...
This AUTOEXEC.BAT file mounts a C drive (pointed to the Local-Directory C:\DOSGAMES), changes to that drive (from Z:), Clears the Screen and prints the message
Hello world...
(The message that MS-DOS printed immediately before loading the CONFIG.SYS and AUTOEXEC.BAT).
MOUNT C C:\oldgames C:
